|
|
CRL 12" Double End Trim Mitre Saw
|
|
|
|
|
|
|
- Fast, Versatile and Accurate
- Make a Variety of Cuts on Both Ends of a Work Piece
This CRL 12" Double End Trim Mitre Saw is fast, versatile and accurate. Two or more saws make a variety of cuts on both ends of a work piece. Lengths are adjusted by a rack and pinion scale. Angles are all calibrated, and set-ups are fast.
Standard Features and Specifications:
Blade Capacity: 12 inch OD (305 millimeter); saw blades not included
Spindle and Pivot: Time tested 200R Series Saw Head; precision ball bearing spindle and pivot shaft are sealed and preloaded for guaranteed accuracy; .001 alignment of spindle and pivot shaft
Arbor: one inch (25 millimeter) with 2-1/2 inch (64 millimeter) saw collars; 3700 RPM of spindle
Motors and Voltages: 2 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motors, 60 Hz, 3450 RPM, with starters and voltage protection
Iron Castings: Tables are precision machined and ground iron castings with milled keyways in tables to guide fences
Table: Saw heads swivel from 90° to 45° towards each other with degree markings and pointer; stops are at 90° and 45°; angular adjustment of saw head away from each other available as option; other angles possible; phenolic chip breaker included
Floor Stand: Heavy gage steel; eight foot centers with traveling right hand carriage on rack and pinion; length measuring scale; optional length centers available to 40 feet (12 meters); Digital Length Measurement available as optional accessory
Blade Guard: Completely encloses blade in rest position. Lower rotating blade guard pivots up into main stationary blade guard as saw heads pivot down to cut
Fences: On each side of blade are keyed to base and are easily adjustable front to back, and side to side
Actuation: Two inside vertical clamps must be tripped by foot valve, then a two-hand anti-tie down, maintained contact safety control will work the air down feed of saw heads. An air filter/regulator/lubricator with auto drain is provided
Air Pressure & Consumption: 75 PSI (5.2kg/cm2); 3 CFM at 75 PSI (.09 cubic meters at 5.2 kg/cm2), based on 10 strokes per minute
Dust Collection: Four, 2 inch round (51 mm) outlets are provided, two on each saw head for DM200R; 800 CFM required per saw head
Production Rates: 10 strokes per minute; actual production rates will vary with type and width of material to be cut
Size and Weight: 32 inches (813 millimeters) front to back x 64 inches (1626 millimeters) High x 120 inches (3048 millimeters) Long; Weight 1,050 pounds (476 kilograms)
|
|
|
|
|
|
|
|
Create new Account
» Simplify Checkout
» View Order Status
» Save Shipping Info
» Track your Orders
|
|
|
|
|
|
|
|
|
|